086 – Power and Speed – Matt from Sloppy

Mike, Tom, and Tad in studio.  No official guest, but lined up (we hope) for the coming weeks. Mike gets pulled into a Mike story about a crazy girl and a Home Depot race car.  This is a 100% true story.  You can’t make up the stuff that happens in life. Internet info.  We have all looked for it, and we have all had to sift through BS to get a real answer for something.  The engine technical side is about as bad as it gets.  Anthony Berton will be on at some point in the future and he is…

Read more

085 – Power and Speed – Ben Strader of EFI University

Mike, Tom, and Tad in studio.   The guys all had a very uneventful week.  Mike abusing stalking Trump, Tom was un-friending everyone, and Tad well… who knows.  With a slow weekend comes a cool Monday. Tonight we have Ben Strader of EFI University.  We really can’t impress on people how much info this guy has.  People should also take note Ben spoke at the AETC conferences, and if you don’t know what that is go check that out.  One thing we can say for sure is one show with him is not going to cut it.  Ben went over some…

Read more

083 – Power and Speed – Matt Happel of Sloppy Mechanics

Mike, Tom, and Tad in studio. We all have our hostile friend. (Mike)  If you are not interested in the election or you are prone to being “Triggered” you might want to skip ahead to 7:15.  Mike is ranting… again.  (but he’s kinda right… again)  Make sure you vote, that is the important thing. Tonights guest is a departure from what we normally have for guests, but that does not mean there is no valid information.  We have had higher level people from higher level companies giving high level information in the past.  BUT, our guest tonight can make a…

Read more

082 – Power and Speed – Alan (Fudd) Returns – Tom at SEMA

Mike, Tad, and Alan (AKA Fudd) in studio, Tom is away at SEMA setting up. Well, it has been a long time since Alan has been around, but he actually volunteered to sit in for Tom.  We hardly noticed a difference at all, and we thank Alan for stopping in. By now all the listeners know Mike might be a little nuts, but when he says something is good, listen to him.  He decided to polish his tractor (yes tractor) and he set out to find the right tool for the job.  We all have seen detailers use a wheel…

Read more